Wheel Installation - JLG 10MSP Operation And Safety Manual

If any of the following is discovered during tire inspection,
measures must be taken to remove the JLG product from ser-
vice immediately. Arrangements must be made for replace-
ment of the tire(s) or tire assembly(s). Both tires/wheels on the
same axle must be replaced:
• If the overall diameter of the tire is less than one of the fol-
lowing:
100 x 323 Tire – 12.25 in. (311mm) minimum
• If any uneven wear is discovered.
A tire with significant damage in the tread area or sidewall
requires immediate evaluation before placing the machine
into service. If a cut, tear, chunk, or other discrepancy
exceeds any one or more of the following dimensions, the
tire must be replaced:
3.0 in. (76 mm) long
0.75 in. (19 mm) wide
0.75 in. (19 mm) deep
• If the metal wheel is visible at any point through the tread
area of the tire.
If more than one discrepancy exists in any quadrant of the
wheel (within 90 degrees of one another).
31215821
SECTION 6 - GENERAL SPECIFICATIONS AND OPERATOR MAINTENANCE

Wheel Installation

WHEEL BOLTS MUST BE INSTALLED AND MAINTAINED AT THE PROPER
TORQUE TO PREVENT LOOSE WHEELS, BROKEN WHEEL BOLTS, AND
POSSIBLE SEPARATION OF WHEEL FROM THE AXLE. BE SURE TO USE
ONLY THE WHEEL BOLTS MATCHED TO THE CONE ANGLE OF THE
WHEEL.
It is extremely important to apply and maintain proper wheel
mounting torque.
6-11