Machine Power Down; Changing The Operator's Code - JLG 10MSP Operation And Safety Manual

Machine Power Down

1.
At the Ground Control Station set the main power
selector switch to the OFF position.
2. Press the OFF button on the PSL
™
the PSL box will be lit.
31215821

Changing the Operator's Code

The Operator's Code can be changed should the need occur. A
separate Permanent Code matched to the serial number of the
PSL
™
keypad. No LEDs on
plied with the machine.
NOTE: ON or OFF cannot be one of the four digits of the new
NOTE: The new Operator's Code will remain in the PSL
SECTION 3 - MACHINE OPERATION
™
box is included on a sheet in the PSL
1.
Enter the Permanent Code on the key pad. The PRO-
GRAM - RED LED will be lit if correct code is entered.
Operator's code.
2.
Enter a new four digit Operator's Code on the keypad.
The ACCEPT - AMBER LED will light up if the new Oper-
ator's Code is accepted.
3. Press the OFF button on the keypad to activate the
new Operator's Code.
when power is removed from the equipment, or until that
code is changed again using the Permanent Code.
™
user manual sup-
™
even
3-39