Hood (Carry Deck); Removal; Installation; Hood (Carry Deck) Removal - JLG 10MSP Operation And Safety Manual

3.5

HOOD (CARRY DECK)

Removal

1.
To remove the hood, loosen the attach screw on the
front of the hood.
2.
Lift the hood at the front to clear the rubber sealing
gasket on the base frame and slide the hood forward
while lifting up to completely remove it from the
machine.

Installation

1.
Set hood down into the hood gasket on the top of the
frame and slide it rearward. Be certain the rear hold-
down bracket engages the hood support underneath
the hood.
2.
Tighten the hood attach screw at the front of the
hood.
DO NOT ALLOW ANY PERSONNEL TO RIDE
ON THE CARRY DECK HOOD.
31215821
SECTION 3 - MACHINE OPERATION
Figure 3-3. Hood (Carry Deck) Removal
1. Hood (Carry Deck)
2. Attach Screw
3
1
2
3. Rear Hold-Down Bracket -Located
Under Hood - Slides Under Hood
Support
3-5