To Charge Batteries - JLG 10MSP Operation And Safety Manual

To Charge Batteries

This machine is equipped with an AC voltage input/DC voltage
output battery charger. The charger automatically terminates
charging when the batteries reach full capacity.
NOTE: The platform drive function is disabled when the battery
charger is plugged into an AC receptacle.
LEAD ACID BATTERIES MAY GENERATE EXPLOSIVE HYDROGEN GAS DURING
NORMAL OPERATION. KEEP SPARKS, FLAMES, AND SMOKING MATERIALS
AWAY FROM BATTERIES. PROVIDE ADEQUATE VENTILATION DURING
CHARGING. NEVER CHARGE A FROZEN BATTERY. STUDY ALL BATTERY MANU-
FACTURERS' SPECIFIC PRECAUTIONS SUCH AS RECOMMENDED RATES OF
CHARGE AND REMOVING OR NOT REMOVING CELL CAPS WHILE CHARGING.
1. Park machine in a well ventilated area near an AC volt-
age electrical wall outlet.
NOTE: To maximize battery life, it is recommended batteries be
charged continuously for a minimum of four hours when
drained to Warning Levels 2 and 3. Refer to Table 3-1.
31215821
SECTION 3 - MACHINE OPERATION
2.
Always
grounded AC outlet.
Connect charger to an
outlet that has been
properly installed and
grounded in accor-
dance with all local
codes and ordinances.
A grounded outlet is
required to reduce risk
of electric shock – do
1
2
not use ground adapt-
ers or modify plug.
When using an exten-
sion cord, avoid exces-
sive voltage drops by
using a grounded 3-
wire 12 AWG cord.
(1) Charger AC Input
Receptacle located on
the rear bumper cover
of the machine.
(2) Battery Charger
Status LED Indicators.
use a
3-7