Platform Control Indicator Panel - JLG 400SJ Operation And Safety Manual

SECTION 3 - MACHINE CONTROLS AND INDICATORS
15. Drive Orientation Override
When the boom is swung over the rear tires or further in
either direction, the Drive Orientation indicator will illu-
minate when the drive function is selected. Push and
release the switch, and within 3 seconds move the
Drive/Steer control to activate drive or steer. Before
driving, locate the black/white orientation arrows on
both the chassis and the platform controls. Move the
drive controls in a direction matching the directional
arrows.
16. Soft Touch Override Switch (If equipped)
Enables the functions that were cut out by the Soft
Touch system to operate again at creep speed, allow-
ing the operator to move the platform away from the
obstacle that caused the shutdown situation.
17. Soft Touch Indicator (If Equipped)
Indicates the Soft Touch bumper is against an object.
All controls are cut out until the override button is
pushed, at which time controls are active in the Creep
Mode.
3-16

Platform Control Indicator Panel

(See Figure 3-7., Platform Control Indicator Panel) and Figure 3-
8., Platform Control Indicator Panel - w/Drive Orientation.
1. Tilt Alarm Warning Light and Alarm
This orange illuminator indicates that the chassis is on
a slope. An alarm will also sound when the chassis is
on a slope and the boom is above horizontal. If lit when
boom is raised or extended, retract and lower to below
horizontal then reposition machine so that it is level
before continuing operation. If the boom is above hori-
zontal and the machine is on a slope, the tilt alarm
warning light will illuminate and an alarm will sound and
CREEP is automatically activated.
IF TILT WARNING LIGHT IS ILLUMINATED WHEN BOOM IS RAISED OR
EXTENDED, RETRACT AND LOWER TO BELOW HORIZONTAL THEN
REPOSITION MACHINE SO THAT IT IS LEVEL BEFORE EXTENDING
BOOM OR RAISING BOOM ABOVE HORIZONTAL.
2. Platform Overload (If equipped)
Indicates the platform has been overloaded.
– JLG Lift – 3121216