Machine Inspection - JLG 10MSP Operation And Safety Manual

• Before operation, check work area for overhead hazards
such as electric lines, bridge cranes, and other potential
overhead obstructions.
• Check operating surfaces for holes, bumps, drop-offs,
obstructions, debris, concealed holes, and other potential
hazards.
• Check the work area for hazardous locations. Do not oper-
ate the machine in hazardous environments unless
approved for that purpose by JLG.
• Ensure that the ground conditions are adequate to support
the maximum tire load indicated on the tire load decals
located on the chassis adjacent to each wheel. Do not travel
on unsupported surfaces.

Machine Inspection

• Do not operate this machine until the inspections and func-
tional checks as specified in Section 2 of this manual have
been performed.
• Do not operate this machine until it has been serviced and
maintained according to requirements specified in the Ser-
vice and Maintenance Manual.
• Ensure all safety devices are operating properly. Modifica-
tion of these devices is a safety violation.
31215821
SECTION 1 - SAFETY PRECAUTIONS
MODIFICATION OR ALTERATION OF A MEWP SHALL BE MADE ONLY WITH
PRIOR WRITTEN PERMISSION FROM THE MANUFACTURER.
• Do not operate any machine on which the safety or instruc-
tion placards or decals are missing or illegible.
• Check the machine for modifications to original compo-
nents. Ensure that any modifications have been approved
by JLG.
• Avoid any build up of debris on platform floor. Keep mud,
oil, grease, and other slippery substances from footwear
and platform floor.
1-3