Tipping Hazards - JLG 10MSP Operation And Safety Manual

SECTION 1 - SAFETY PRECAUTIONS

Tipping Hazards

1-8
• Ensure that the ground conditions are adequate to support
the maximum tire load indicated on the tire load decals
located on the chassis adjacent to each wheel. Do not travel
on unsupported surfaces.
• Do not elevate platform or drive with platform elevated
while on or near a sloping, uneven, or soft surface. Ensure
machine is positioned on a smooth, firm surface within the
limits of the maximum operating slope before elevating
platform or driving with the platform in the elevated posi-
tion.
• Before driving on floors, bridges, trucks, and other surfaces,
check allowable capacity of the surfaces.
• Never exceed the maximum platform capacity as specified
on the platform. Distribute loads evenly on platform floor
and material tray.
• Keep the chassis of the machine a minimum of 2
from holes, bumps, drop-offs, obstructions, debris, con-
cealed holes, and other potential hazards at the ground
level.
• Never attempt to use the machine as a crane. Do not tie-off
machine to any adjacent structure. Never attach wire, cable,
or any similar items to platform.
• Do not operate the machine when wind conditions exceed
0 mph (0 khp).
ft. (0.6 m)
31215821