AeroNav 900/880 Series Pilot's Guide
HDI Turned On
SYNTHETIC VISION WITH DATABLOCKS
The default SynVis view shows radio controls, datablocks, and
LSKs on the left and the entire right side of the display shows the
SynVis scene. However, SynVis can be configured to show
datablocks in a narrow area on the right side of the display.
When configured to show datablocks, the datablocks overlay the
terrain and the SynVis view is re-centered in the available space.
To show the datablocks, touch the "Data" tab on the right side of
the display. Holding the left side of the SVS button will also
cause the datablocks to appear. To hide the datablocks, either
touch the "Data" tab to the left of the datablocks, or hold the right
side of the SVS button until they slide back off of the display.
The datablocks to be shown are configurable as described in
Datablock Setup, page 5-20. This is the same set of datablocks
that can be shown on the Map page.
89000039-010
Rev 1 May 2019
SVS Subsystem 2-7