Selecting A Network Configuration - BENDIXKing AeroNav 910 Pilot's Manual

NOTE
Spaces at the end of the PSK will not be contained
in the final PSK. In other words,
"PASSWORD<SP><SP>" will present a network
PSK of "PASSWORD".
Non empty PSKs must contain at least 8 characters.
If there are fewer than 8 characters, the system will
fill missing characters with a '?' character.
Empty PSKs are allowed, though not recommended.
Entering the network mode
The mode is a fixed selection field that can contain either "Local
Wi-Fi" or "Remote Wi-Fi". To change the selection, rotate the
right inner knob. Again, "Local Wi-Fi" should be selected to make
the AeroNav be the network WAP and "Remote Wi-Fi" should be
selected to connect the AeroNav as a client on another network.
TIPS AND TECHNIQUES
If you sometimes connect your IFD100 through a
Stratus and other times directly to the AeroNav,
define two WiFi configurations in maintenance
mode. When you want to switch between
configurations, you can do that using flight mode
only.

SELECTING A NETWORK CONFIGURATION

After one or more WiFi network configurations has been defined
in maintenance mode, flight mode is used to select which of those
configurations is to be used.
Start the AeroNav in flight mode. Acknowledge any startup
screens, go to the AUX page SETUP tab, and then select the
"User Options" LSK. Using the right outer knob, move the cursor
to the "Networking" item in the list.
89000039-010
Rev 1 May 2019
AeroNav 900/880 Series Pilot's Guide
General 7-75