BENDIXKing AeroNav 910 Pilot's Manual page 127

COOL FEATURE
PROC button
The PROC function key on the bezel acts as a
shortcut for attaching a published arrival or approach
procedure to a waypoint in your flight plan. It can be
used at any time. The first press of the function key
results in the AeroNav displaying the FPL tab (Map-
FPL view) of the FMS page with the cursor on the
Approach field of the next destination after the active
leg and a dropdown containing the available
published approaches. Pressing PROC a second
time will move the cursor to the Arrival field and
present a dropdown of available published arrivals.
Each subsequent press of the PROC key will step
through all following destination airfields approaches
and arrivals in the flight plan and wrap back around
to the top of the flight plan. When the dropdown is
presented for the intended field, use either the right
knob button or touch to scroll the list until the desired
procedure is selected, then push the right knob
button to add that procedure to the flight plan.
If there is no flight plan, then pressing the PROC
function key will present the FPL tab on the AeroNav
with an insert cursor at the top of the page but will
not present any procedures.
TIPS AND TECHNIQUES
Changing Selected Approach Type on Final †
If a VHF-based approach has been activated and
then is replaced with a new GPS-based approach
prior to activating the missed approach, it may be
necessary to manually change the nav source mode
(e.g. manually change VLOC to GPS if switching
from an ILS to a RNAV).
89000039-010
Rev 1 May 2019
AeroNav 900/880 Series Pilot's Guide
FMS Subsystem 3-33