Editing A Holding Pattern; Activating A Flight Plan; Flight Plan Sequencing - BENDIXKing AeroNav 910 Pilot's Manual

AeroNav 900/880 Series Pilot's Guide

EDITING A HOLDING PATTERN

To edit a holding pattern, rotate the right outer knob to scroll until
an edit cursor surrounds the hold, or touch the hold to be edited.
Then rotate the right inner knob or touch the field to be edited to
highlight the desired field (e.g. turn direction, leg length, leg units,
inbound leg course). Press the right knob button or touch the
selected field to start making the edit.
COOL FEATURE
Graphical Flight Plan Leg
To aid in situational awareness, procedure turns and
holding patterns are shown in the flight plan with a
graphical representation, as illustrated below.
Procedure Turn Leg

ACTIVATING A FLIGHT PLAN

When a flight plan is entered on the ground, the flight plan will be
inactive and no guidance will be provided. To activate the flight
plan, press the "Activate Route" LSK. If the flight plan is not
activated and the aircraft reaches a threshold groundspeed of
approximately 40 knots, the AeroNav will automatically activate
the flight plan. A flight plan that was created by pressing the
"Activate Route" LSK for a stored route on the ROUTE tab will be
automatically activated.

FLIGHT PLAN SEQUENCING

The FMS assumes that the pilot will fly the flight plan as defined.
If that does not occur, legs may not sequence as expected.
Therefore, to manually sequence the desired leg, select it by
either using the bottom right AeroNav knob or touch it and press
3-24 FMS Subsystem
89000039-010
Rev 1 May 2019