Start-Up Sequence - BENDIXKing AeroNav 910 Pilot's Manual

AeroNav 900/880 Series Pilot's Guide

START-UP SEQUENCE

The startup sequence of the AeroNav is as follows:

An BendixKing logo will be displayed during system
initialization and will be automatically removed when the
AeroNav is initialized. The bezel keys will not be
illuminated while the splash screen is present.

An agreement of the limitation of your legal rights must
be made via the bezel "ENTR" button. While the
agreement page is displayed, the AeroNav is activating
the signals that connect with a remote annunciator panel
as well as outputting self-test data to external devices, to
be used as a lamp test and external signal check.

If there is a third party weather or traffic sensor
connected to the AeroNav, then a vendor mandated
disclaimer page may be presented advising the pilot it is
their responsibility to see and avoid traffic and determine
weather conditions. There is no pilot action that must be
performed on this page and it will automatically be
removed after several seconds.

A software version and database currency page is
displayed only if there any expired databases.
BendixKing does not recommend operating with expired
databases but the system will allow operation by pressing
the "Proceed" followed by the "Confirm" LSKs.

If the AeroNav has been enabled for Bluetooth and WiFi
and either of those subsystems have been configured
"On" on the User Options page, then the AeroNav will
present an Allow/Ignore page to allow external data
receipt via Bluetooth and/or WiFi. Press the Allow button
if such input is desired or the Ignore button if no external
input is desired. Pressing Ignore will automatically toggle
the User Option selections to Off and will remain that way
until manually turned back on.

If there is a fuel flow system connected to the AeroNav,
then the AeroNav will automatically transition to the Fuel
Management Page. If the fuel flow system does not
provide fuel totalizer data, you will need to input the fuel
on board and press the "ENTR" key. If the fuel flow
system does provide fuel totalizer data, confirm the total
is correct and press the "ENTR" key.
1-18 System Overview
89000039-010
Rev 1 May 2019