Transition Altitudes/Levels - BENDIXKing AeroNav 910 Pilot's Manual

AeroNav 900/880 Series Pilot's Guide

TRANSITION ALTITUDES/LEVELS

Transition altitude/level alerts can be optionally turned on via the
FMS Setup page. When set to On, an advisory CAS message
will be displayed as the transition altitude is being approached
from below or when the transition level is approached from
above.
If the origin airport has a published transition altitude in the nav
database and the transition altitude has not been manually set,
the system will automatically set the transition altitude.
If the destination airport has a published transition level in the nav
database and the transition level has not been manually set, the
system will automatically set the transition level.
The transition altitude can be manually set on the FMS Setup
page by twisting the inner ring of the bottom right knob or by
typing in a value in the virtual keyboard. Each click of the inner
ring adjusts the value by 100 feet and keyboard entries can be
made down to the foot. The allowable range is from 1,000 feet to
60,000 feet.
Similarly, the transition level can be manually set on the FMS
Setup page by twisting the inner ring of the bottom right knob or
by typing in a value in the virtual keyboard. Each click of the
inner ring adjusts the value by one flight level (i.e. 100 feet). The
allowable range is from FL010 to FL600.
When the transition altitude/level has been automatically set by
the system, it is displayed in green. If the transition altitude/level
has been manually entered, it is displayed in white. When the
transition altitude/level has been manually set, pressing the bezel
"CLR" button will allow the value to be set by the system, turning
it from white to green.
89000039-010
6-20 Navigation Rev 1 May 2019