Flight Plan Discontinuities (Gaps) - BENDIXKing AeroNav 910 Pilot's Manual

AeroNav 900/880 Series Pilot's Guide
lateral offset, press the "Delete Offset" LSK. The maximum offset
that can be dialed in is 20 NM. Lateral offsets are not available
when in OBS mode. Lateral offsets are unaffected by graphical
route planning ("rubber banding") operations.
Lateral Offset Map Depiction

FLIGHT PLAN DISCONTINUITIES (GAPS)

A "Gap In Route" will appear within the flight plan when there is a
discontinuity between legs. A discontinuity occurs when the FMS
cannot compute the guidance to the next leg due to an invalid leg
type combination based on preset guidance rules. The objective
is to inform the pilot that the Gap must be manually closed if you
wish to sequence to the next waypoint. Otherwise, the leg before
the Gap will not be sequenced and guidance will not be provided
to the next waypoint. If desired, close the gap by placing the
cursor on it using the bottom right AeroNav knob or by touching it.
Press the "CLR" bezel key or the L4 LSK on the FPL tab,
"Connect <wpt1> & <wpt2>". Closing a Gap connects the
89000039-010
3-26 FMS Subsystem Rev 1 May 2019