BENDIXKing AeroNav 910 Pilot's Manual page 296

AeroNav 900/880 Series Pilot's Guide
Integration
Category
"Cooperative"
electronics
NOTE
Manual Sequencing May Be Required
In Electro-mechanical installations where the
AeroNav does not have an altitude input, a CAS
message ("Manual Sequence Req'd") prompting the
pilot to manually sequence legs of the flight plan will
be presented on Heading-to-Altitude leg types (e.g.
some missed approach legs). Since the AeroNav
does not know altitude in this case, it does not know
when to sequence to the next leg. Failure to
manually sequence to the next leg will result in the
AeroNav maintaining the leg heading indefinitely.
6-4 Navigation
Description
The "cooperative"
system is even more
capable than the
AeroNav and,
therefore, is the
primary navigation
control device.
All nav source
selection and course
setting is performed
on the external device.
The AeroNav
becomes a "slave" to
the external device.
AeroNav
Functionality
Course values will
display on the
AeroNav but are
set on the external
device(s).
Nav source modes
available:
None (the nav
source knob/button
will appear to be
non-functional).
89000039-010
Rev 1 May 2019