BENDIXKing AeroNav 910 Pilot's Manual page 308

AeroNav 900/880 Series Pilot's Guide
L4 LSK Label
Skip Hold
Sequence
Leg
Enable A/P
Approach
6-16 Navigation
Displayed when the aircraft is within 5 nm of
the FAF and the next leg is a database
procedure hold. Pressing the LSK will
sequence the active leg past the hold without
entering it when the aircraft reaches the FAF.
The leg after the hold will become active.
Displayed when there is no altitude source and
the active leg terminates at an
altitude. Pressing the LSK upon reaching the
altitude is required to sequence to the next leg.
Displayed for specific autopilots (e.g. KAP140,
KFC225) when the FMS determines it is time
for the autopilot to be in Approach mode but
does not have any control or knowledge of the
actual autopilot state. This case is just a
prompt, and no pilot action must be taken on
the AeroNav.
Comments
89000039-010
Rev 1 May 2019