Exiting Maintenance Mode - BENDIXKing AeroNav 910 Pilot's Manual

AeroNav 900/880 Series Pilot's Guide
Update Databases LSK
The Update Databases LSK is intended for use when updating
databases. Press the Status LSK until Databases is selected.
Then press "Update Databases", which will have appeared by the
bottom left LSK (L4). At that point, the LSKs will be changed to
"Confirm" and "Cancel". Press Confirm to switch to maintenance
mode. When the system restarts into maintenance mode, the
"Update" tab will be selected.
Update Databases LSK

EXITING MAINTENANCE MODE

To return to flight mode from maintenance mode, select the
Update tab either by touching that tab or by pressing the left side
of the AUX button until that tab is selected. At that point, a
"Done" LSK will be presented on the right side of the display,
adjacent to the ENTR button. When the Done button is pressed,
either by touchscreen or by the ENTR key), the display will show
a countdown. Pressing CLR or Cancel will cause the system to
remain in maintenance mode. Once the countdown expires, the
AeroNav will reboot back into flight mode.
89000039-010
7-54 General Rev 1 May 2019