Graphical Flight Planning ("Rubber Banding") - BENDIXKing AeroNav 910 Pilot's Manual

AeroNav 900/880 Series Pilot's Guide

GRAPHICAL FLIGHT PLANNING ("RUBBER BANDING")

A flight plan can be altered graphically by touching the desired leg or
the desired waypoint on the map depiction, placing your finger on the
leg for approximately 2 seconds until the leg turns cyan, and then,
without lifting your finger off the display, dragging your finger to the
desired location. When you lift your finger off the display, a dialog
box is presented on the display for you to choose/confirm the new
waypoint being created.
If the new fix is in close proximity to a facility or facilities in the on-
board navigation database, then both the fix and the nearby facility or
facilities will appear in the dialog box list.
Rubber Banding Dialog Box
If the intended new waypoint is not listed in the dialog box to your
satisfaction, press the bezel "CLR" button to clear and restart as
required.
As soon as a fix from the presented list is selected, a new waypoint is
inserted in the FPL flight plan list and uses a default waypoint naming
mechanism ("RBxxx" where "RB" stands for Rubber Banding). This
89000039-010
4-14 Map Subsystem Rev 1 May 2019