Map Setup - BENDIXKing AeroNav 910 Pilot's Manual

AeroNav 900/880 Series Pilot's Guide

MAP SETUP

The level of detail and the choice of displaying elements on the
map may be controlled from the AUX page by choosing the
SETUP tab and the "Setup Map" LSK.
Map Setup
The Airport Filters section provides a location to specify the
runway length, runway surface, airport tower status, and type of
fuel available. Airports that meet these various filter definitions
will be displayed on the moving map.
The Map General section provides a means to turn the map
compass rose on/off and to command the map declutter algorithm
as to whether to use the altitude filter, as well as a means to turn
the heading/track digital readout box on the map on/off. This is
also the place to select one of the pre-defined map detail defaults
(VFR, IFR, Factory, Custom). Restoring factory defaults is
accomplished by pressing the bottom right AeroNav knob and
then accepting the Confirm dialog box.
The Map Detail section provides a location to define the level of
map detail. Options include element labels on the map, selecting
a range and an altitude beyond which the element is no longer
displayed, and defining the declutter priority levels.
89000039-010
5-36 Aux Subsystem Rev 1 May 2019