Self Test Output - BENDIXKing AeroNav 910 Pilot's Manual

AeroNav 900/880 Series Pilot's Guide

SELF TEST OUTPUT

For the duration that the notification of legal rights page is
displayed during normal power up on the ground, all remote
annunciator lamps are lit up and the system generates a specific
set of electrical outputs for the purpose of self-test and
troubleshooting. The table below defines the outputs transmitted
during this time.
Parameter
Course Deviation
Glideslope/Vertical
Deviation
Annunciators
Bearing to Waypoint
(RMI)
Selected Course
(OBS)
Desired Track
Distance To Go
Time To Go
Active Waypoint
Groundspeed
Present Position
Waypoint Alert
Phase of Flight
Message Alert
GPS Integrity
Roll Steering (if
applicable)
7-26 General
Self-test Value
Half-scale left deviation, TO
indication, flag stowed
Half-scale up deviation, flag stowed
All on
135°
150° when interfaced to an HSI with
course pointer
150°
10.0 NM
4 minutes
"AVDYN"
150 knots
N39°04.05', W094°53.86'
Active
Enroute
Active
Invalid
Flight Director commands 0° bank
(level flight) for 5 seconds; commands
increasing right bank at 1°/second for
5 seconds; commands 5° right bank
for 5 seconds; commands decreasing
right bank at 1°/second for 5 seconds,
until command is 0° bank again. This
cycle repeats continuously.
89000039-010
Rev 1 May 2019