Maintenance And Inspection; 10-1) Check Points For Regular Inspection; 10-2) Cleaning - SunStar SWF/B Series User Manual

MAINTENANCE AND INSPECTION

Consumable parts shall not be guaranteed even in warranty period.

10-1) CHECK POINTS FOR REGULAR INSPECTION

Safety rules must be observed during the inspection.
CAUTION
1) Clean, oil, and grease the set parts of the machine on a regular basis.
2) Inspect tension of each driver belt.
3) Failure to perform regular inspections may cause the following:
• Corrosion of P/C circuit board
• Damage to the semi-conductor on P/C circuit board
• Malfunction of the floppy disk drive
• Ill connection of the connector
• Abnormal wear-out of machine parts due to insufficient oiling and greasing

10-2) CLEANING

SWF is not responsible for machine damages or malfunction due to no or irregular machine inspections
including cleaning and oiling.
CAUTION
Make sure the main power is turned off before inspection or cleaning.
Set your regular cleaning timetable according to the machine conditions and environment.
CAUTION
NO
1 Around the hook
2 Guide rail to the take-up lever
Around the movable blade and the fixed blade
3
Important Parts to Clean
[ How to Clean ]
※ Remove the needle plate and pull the
movable blade forward.
※ Use the SWF brush to remove dirt and
dust.
CHAPTER
1 1 0 0 - - 1 1
10
Cleaning cycle Reference Fig.
Every day
Once a week
Once in
3-7 days
①
②
③