SunStar SWF/B Series User Manual page 58

■ New Menu for Design Calls
→ Revision of the functions in "7.4.1. In & Out of Design"
Select a design using EMB CALL or FDD CALL and you will see the following screen.
1. BASIC SETTING: menu for basic set-up
2. NEEDLE SETTING: menu for needle bar set-up
3. EMB CALL: menu for design selection
Place the cursor at "1. BASIC SETTING" and press
Basic set-up procedure is the same as pressing (
Press ( ) to end the set-up.
Place the cursor at "2. NEEDLE SETTING" and press
Needle set-up procedure is the same as pressing (
Press ( ) to end the set-up.
At [Screen 1], you can press (
1. BASIC SETTING
2. NEEDLE SETTING
3. EMB CALL
[ Screen 1 ]
1] X_SCALE :
2] Y_SCALE :
3] ANGLE :
4] MIRROR :
[ Screen 2 ]
) from the start menu.
==== NEEDLE SELECT
[1
[END] [INSERT]
[ Screen 3 ]
) to start embroidery work or select "3. EMB CALL" to re-select design.
to do basic set-up.
100[%]
100[%]
0
NO MIRROR
to set-up the needle bar.
====
]: 1 / 1
[DEL]
) from the start menu.