8-4) Encoder; 8-5) Repetition Work; 8-6) Floppy Drive And Communication - SunStar SWF/B Series User Manual

8-4) ENCODER

NO. ERROR MESSAGE
400 Encoder A signal dose not vary
401 Encoder Z signal does not vary

8-5) REPETITION WORK

NO. ERROR MESSAGE
Repeat setting error
501
(X number*Y number 99)

8-6) FLOPPY DRIVE AND COMMUNICATION

NO. ERROR MESSAGE
600 Floppy drive is not ready
601 Diskette sector is not found
602 Diskette drive a file is not found
603 Write protect error
604 This diskette is error
605 Diskette space is insufficient
606 Drive open error
607 Floppy reading error
608 Floppy writing error
609 Floppy driver error
610 Floppy driver error
611
ZSF, Barudan disk is not available
612
613 Too many bad sectors
ERROR
Error in A of the main shaft
encoder.
Error in Z of the main shaft
encoder.
ERROR
Exceeded the set limit for
repetition work
ERROR
No disk in the drive.
Disk is not formatted or is of a
different format.
No embroidery design in the disk.
Disk is write-protected.
Damaged disk.
No space in the disk for copying.
Disk was removed during
operation.
Bad sectors in the disk.
Bad sectors in the disk.
Unknown disk error during
operation.
Unknown disk error.
Damaged disk.
Damaged disk
(occurred during formatting)
CORRECTION
Check cable connection. Turn the
main power OFF and ON again.
Check cable connection. Turn the
main power OFF and ON again.
CORRECTION
Reset the limit so X*Y does not
exceed 99.
CORRECTION
Insert the disk in the drive.
Format or change the disk.
Change the disk.
Remove the protection tab.
Format or change the disk.
Change the disk.
Insert the disk and re-work.
Format or change the disk.
Format or change the disk.
Format or change the disk.
Try with a new disk.
Try with a new disk.
Try with a new disk.