Chapter 9 Maintenance And Inspection; 9-1) Check Points For Regular Inspection; 9-2) Cleaning - SunStar SWF/B Series User Manual

MAINTENANCE AND INSPECTION
Consumable parts shall not be guaranteed even in warranty period.

9-1) CHECK POINTS FOR REGULAR INSPECTION

Safety rules must be observed during the inspection.
CAUTION
1) Clean, oil, and grease the set parts of the machine on a regular basis.
2) Inspect tension of each driver belt.
3) Failure to perform regular inspections may cause the following:
• Corrosion of P/C circuit board
• Damage to the semi-conductor on P/C circuit board
• Malfunction of the floppy disk drive
• Ill connection of the connector
• Abnormal wear-out of machine parts due to insufficient oiling and greasing

9-2) CLEANING

Turn OFF the main power before inspection or cleaning.
CAUTION
NO
1 Around the hook
2 Guide rail to the take-up lever
3 Around the movable blade and the fixed blade
[How to Clean]
Remove the needle plate. Manually turn the trimmer
driver knob (④) using the color change handle and
the movable blade will move. Make sure the power is
OFF. After cleaning, turn the power on and the blade
will automatically return to the basic set position.
Use the SWF brush to remove dirt and dust.
Important Parts for Cleaning
9-1
CHAPTER
Cleaning cycle Reference Fig.
Every day
Once a week
Once in 3-7 days
9
①
②
③