7-4-5) Embroidery Data Set-Up - SunStar SWF/B Series User Manual

7-4-5) Embroidery Data Set-up

Press when the operating system loads and you will see the following screen: There are 2 sub menus for
data set-up.
1. EMB FUNCTION: sets parameters for the embroidery work.
2. MACHINE FUNCTION: sets parameters for the machine operation.
• Setting parameters
Move the cursor to the desired parameter number and input the data within the "RANGE" indicated on the screen.
• Storing the set-up data
Change the set-up data and press
■ EMB FUNCTION
(1) TOTAL STITCH CLEAR (Total number of stitches)
Along with TOTAL ST in the main function menu, this indicates the number of stitches from clear to present.
This is also used to clear the set-up data. (Only the numerical key "0" works)
(2) TOTAL WORK CLEAR (Total number of table sets)
Along with TOTAL WK in the main function menu, this indicates the number of table sets from clear to present.
(Only the numerical key "0" works)
(3) JUMP CONVERT (Maximum number of repeated jump stitches)
The machine trims if jump code is repeated more than the set-up data. You will need to set-up the number of
repeated jump stitches required for long stitch work. The default is 3 stitches and the range is from 0 to 10 in the
increments of 1 stitch.
to store the data.
1] TOTAL STITCH CLEAR
2] TOTAL WORK CLEAR
3] JUMP CONVERT:3st
4] AUTO ORIGIN:YES