Error Type
Bad Color
Incorrect position of needle
Change
stop
Failure to sense signals for
needle position or 1 rotation
Incorrect position of needle
bar
Incorrect position of take-up
lever
Fuse failure for color
change motor
Bad connection
Cause
Refer to user' s manual
Run manual color change and
adjust so the operation box
indicates normal needle
position signal
Set it to the correct position
Adjust so take-up lever is in
line with other levers in stop
position (upper shaft
angle:100° )
Change fuse F3 in joint board
or check connection
Inspection & Repair
Reference
Set main shaft angle back
at 100° , if you manually
moved it for cleaning,
inspection or repair.
Unscrew the lever and
adjust so it is in line with
the others on the guide rail.
Check fuse rating
See 9-1