SunStar SWF/B Series User Manual page 26

① START/STOP for starting embroidery and stopping machine
BUTTON OPERATION
Press START
Hold START
Press STOP
[ Note ]
You cannot perform non-stitching (floating) at the start of the embroidery floating is not in the start menu. To perform
floating at the start, press STOP to put the machine in STOP MODE. Then press
stitching function.
② START/STOP during machine stop
BUTTON OPERATION
Press STOP
Hold STOP
Press STOP again
③ START/STOP during forward non-stitching (during work stop)
Refer to "7-4-8. Float (Non-Stitching) Functions."
BUTTON OPERATION
Press START
Hold START
Press START again
④ START /STOP during backward non-stitching (during work stop)
See (2) START/STOP during machine stop.
⑤ Performing work other than embroidery
If you want to perform a solenoid test, a thread break sensor test, or manual trimming, select the function and press
START.
[ Note 1 ]
"Inching" refers to low-speed embroidery at a 100 rpm range, performed for stable stitching when the machine is re-
started after stop.
[ Note 2 ]
"Frame movement unit" refers to the "BK STITCH UNIT" in "EMB FUNCTION." You can select from 1 to 10 stitches
(by 1 stitch).
Machine starts and embroidery work begins.
Machine "inches (see Note1)" until you release the button.
Machine stops.
Frame moves backward in selected movement units (see Note 2).
If you press STOP before the machine goes 10 of the selected stitches, the
machine will stop immediately (the machine moves back in the selected
movement units). If you press STOP after the machine traveled 10 of the
selected stitches, the machine will continue to move back.
Press STOP one more time and the machine will stop moving backward.
Frame moves forward in selected movement units (see Note 2)
Frame starts to move forward.
If you press START before the machine goes 10 of the selected stitches,
the machine will stop immediately (the machine moves back in the selected
movement units). If you press START after the machine traveled 10 of the
selected stitches, the machine will continue to move forward.
Press START one more time and the machine will stop moving forward.
Select function
MACHINE OPERATION
MACHINE OPERATION
MACHINE OPERATION
Press START
button to select the non-