11-7) ADJUSTING HALF-TURN FILM FOR COLOR CHANGE
Adjust the half-turn film as shown below if the needle does not come to the center of the needle hole on the plate
after an automatic color change.
① Turn handle and adjust the color change cam so that the roller is on the center of the cam on the straight lines.
Open the cover of the half-turn sensor and adjust so that the center of the half-turn sensor coincides with the
center of the half-turn film.
[ CAUTION ]
Manual color change must be performed at the upper shaft angle of 100°.
If the needle is not on the center of the hole after adjustment of the half-turn film, contact the nearest SWF
distributor or engineer.
Half-turn Sensor
Half-turn Film
Half-turn Sensor
Color change cam
[Fig. 11-14]