Installation And Machine Assembly; 2-1) Environment; 2-2) Electricity - SunStar SWF/B Series User Manual

INSTALLATION AND MACHINE ASSEMBLY

Install your machine in an appropriate environment and with adequate electrical supply. Failure to follow the
directions may result in machine malfunction.

2-1) ENVIRONMENT

1) Temperature:
(1) 0~40°C (32~104°F) when machine is in operation
−25~55°C (-13~131°F) when the machine is not in operation
(2)
2) Humidity: 45~90% (relative)
[ Caution ]
• Do not let moisture drops on the machine.
• Provide air conditioning to control humidity and to eliminate dust and corrosion.
3) Grounding: Ensure the electricity is properly grounded.
Properly ground the machine to avoid a possibility of electric shock. Use three-wire grounding
(grounding resistance below 100 ohms).
Danger
4) Close any doors and windows near the machine to prevent direct light, dust, and humidity.
5) Foundation under the machine must be strong enough to support the weight of the machine.

2-2) ELECTRICITY

Check if the input voltage of the machine is in the right range of the voltage supply before installing or operating
the machine. The input voltage is as follows:
1) Input voltage (adjust when installing): 100V, 110V, 120V, 200V, 220V, 240V
2) Allowed range of voltage: within 10% of the voltage set.
3) Electric capacity and Minimum input voltage: 600VA (400W)
4) Insulation resistance: over 10M ohms (measured with 500V insulation tester)
• Check the voltage supply where the machine will be installed.
• Install the cable away from the
Warning
operator' s work space to prevent accident or injury.
CHAPTER
2