7-4-11) Manual Cutting; 7-4-12) Offset Set-Up - SunStar SWF/B Series User Manual

7-4-11) Manual Cutting

Press when the operating system loads and you will see the following screen:
You can perform manual trimming other than the automatic trimming set by DESIGN CODE. Press the START on
the menu screen above and the machine will start trimming automatically. Press

7-4-12) Offset Set-up

Press when the operating system loads and the following screen will appear:
This sets the frame to automatically move to the location you selected at start or finish of the embroidery work.
This function may be useful for frame change or fabric arrangement. Select the following four types of data for the
offset function.
(1) START POINT
The start point of embroidery
(2) MIDDLE OFFSET
The middle point to prevent needle accidents when the frame moves to the offset point
(3) OFFSET POINT
The point to where the frame should automatically move when it reaches the offset point set by needle bar
(4) Set "0" for the desired offset point in the Needle Bar Set-Up (see 7.4.13)
TRIMMING OPERATION
RUN => START SWITCH
CANCEL => PREVIOUS
=== START POINT
=> FRAME MOVE
to cancel.
===