SunStar SWF/B Series User Manual page 76

Interval of +20mm
start point of design
• X/Y PRIORITY
Set the priority between X and Y directions.
[ X set as priority ]
• DESIGN INTERVAL
You can select STOP CODE or JUMP CODE to move the design.
STOP CODE : a design moves to the next location and stops.
JUMP CODE : a design moves to the next location and automatically start work.
• NEEDLE BAR SET-UP
Needle bar set-up should be different for STOP and JUMP CODES.
① STOP CODE: color change is automatically added at the start point of the design. In the case of using four
colors, the following revisions are made.
② JUMP CODE: color change is not added automatically, so you are to select the exact number of colors used.
(+ 20 mm)
move
Interval of –20mm
start point of design
move
(–20 mm)
[ Y set as priority ]