SunStar SWF/B Series User Manual page 81

(4) AUTO ORIGIN (Return to the start position)
This move the frame back to the start position after work is finished. The default is "YES."Select "0"for
"NO" if you do not want to use this function.
(5) STOP INCHING (Number of inchings at the beginning)
The machine inches slowly when it starts. You can set up the number of stitches to inch. The default is 2
stitches and the range is between 0 and 5 (in the increments of 1 stitch).
(6) TRIM INCHING (Number of inchings after trimming)
The machine inches slowly when it detects a signal for color change or finishes embroidery for one design.
You can set up the number of stitches to inch. The default is 3 stitches and the range is from 2 to 5 (in the
increments of 1 stitch).
(7) AUTO JUMP (Interval of automatic jump stitches)
The machine automatically changes to JUMP CODE if the interval between the two stitches is longer than the
set-up data. You can set the standard number of stitches for the automatic change to o JUMP CODE. The
default is 10.0mm and the range is between 5.0mm and 12.7mm in the increments of 0.1 mm.
(8) BK_ST UNIT (Back stitching unit)
This sets the number of stitches to be made at a single bar switch action when you do forward or backward
stitching using the bar switch. The default is 1 stitch and the range is 1-10 stitches in the increments of 1 stitch.
(9) BK_ST START (Automatic start after back stitching)
When you move the frame back from the stopped position to work with a bar switch, you can set whether the
stitching will start automatically. The default is "YES" and you can select "0" for "NO."
(10) BK_ST ALL (Previous needle bar operation after back stitching)
When you move the frame from its stopped position and start embroidery with a bar switch, you can set whether
only the head with broken thread will operate or all heads will operate. The default is "EACH (single)"and you
can input "1" to select "ALL."
(11) TRIM START (Automatic start after trimming)
You can set whether embroidery work will start automatically after trimming by JUMP CODE, TRIMMING,
and STOP CODE. The default is "YES" and you can select "0" to set at "NO."
4 JUMP STEP
: No Trimming, Jump Stitch
5 JUMP STEP
: Trimming and Frame Move