Advertisement
Table of Contents
SWF EMBROIDERY MACHINE
DM-M-22
[G] ARM
A. Content
B. Order
C. Details
Picture 1
Picture 2
─ Ver.2009 1st
How to Replace the Presser Foot Driving Cam
No.
Order
Remove the top shaft cover
1
Remove the head
2
Remove the arm protection
3
plate and side cover
4
Set the presser foot
driving cam
Top Shaft Cover
────────────────────── SunStar Co., Ltd ─
CD CODE No:
Tools Required
+driver, 3mm T-wrench
+driver, -driver
4mm T-wrench
1.Remove the Top Shaft Cover
1) Change the color to the last needle bar to secure
the sufficient space for the following steps.
2) Remove the top shaft cover.
2.Remove Head
1)Remove the head face plate (U) with +driver
and then use 3mm T-wrench to remove the head from the arm.
JIG /
Instruments
Corner Driver
presser foot driving
cam setup JIG pin
Advertisement
Table of Contents
Related Manuals for SunStar SWF
Summary of Contents for SunStar SWF
- Page 1 2) Remove the top shaft cover. Picture 1 Top Shaft Cover 2.Remove Head 1)Remove the head face plate (U) with +driver and then use 3mm T-wrench to remove the head from the arm. Picture 2 ─ Ver.2009 1st ────────────────────── SunStar Co., Ltd ─...
- Page 2 Refer to Picture 5, 6 Caution ) At this time, check that the cutting part of presser foot driving cam collar matches with the cutting part of presser foot driving cam. Picture 5 ─ Ver.2009 1st ────────────────────── SunStar Co., Ltd ─...
- Page 3 & the Side Cover 1) Assemble them in reverse of disassembly. 6.Assemble the Head 1) Assemble them in reverse of disassembly. 7.Assemble the Top Shaft Cover 1) Assemble them in reverse of disassembly. ─ Ver.2009 1st ────────────────────── SunStar Co., Ltd ─...
Need help?
Do you have a question about the SWF and is the answer not in the manual?
Questions and answers