SunStar SWF Quick Start Manual

SWF EMBROIDERY MACHINE
SWB-M-56
[K] HEAD
A. Content
B. Order
C. Details
Head Face Head Face
Plate(L) Plate(U)
Picture 1
─ Ver.2009 1st

How to Replace the Presser Foot Pressure Spring

No. Order
1 Remove the thread
tension adjusting plate
2 Remove the head face plate
3 Replace the presser foot
pressure spring
4 Set the upper dead &
lower drop point and
the presser foot height
5 Assemble the thread
tension adjusting plate
6 Assemble The Head Face Plate
1. Remove the Thread Tension Adjusting
Head
2.Remove the Head Face Plate
────────────────────── SunStar Co., Ltd ─
CD CODE No:
Tools Required
3mm T-wrench,＋driver
＋driver,－driver
－driver(small)
2.5 T-wrench
manual knob, presser
foot height control
rubber (0.5t,1t)
3mm T-wrench,＋driver
＋driver,－driver
Plate
Refer to Picture 1
1)Change the color at a position that the needle bar
to be replaced does not interfere with reciprocator.
(If the presser foot of #2 needle bar is replaced,
change the color with a needle bar other than #2)
2)Remove the thread tension adjusting plate.
1) Remove the head face plate (L) & (U).
Refer to Picture 1
JIG /
Instruments
lower drop
point gauge
and presser
foot
height gauge