Table of Contents
Advertisement
2.5) Repair and Maintenance
Danger
2.6) Safety Labels
CAUTION
경 고
Do not operate without finger guard and
safety devices. Before threading, changing
bobbin and needle, cleaning etc. switch
off main switch.
손가락 보호대와 안전장치 없이 작동하지
마십시오.
실, 보빈, 바늘교환시나 청소전에는 반드시
주전원의 스위치를 꺼 주십시오.
WARNING
경 고
Hazardous voltage will cause injury.
Be sure to wait at least 360 seconds
before opening this cover after turn off
main switch and unplug a power cord.
고압 전류에 의해 감전될 수 있으므로 커버를
열 때는 전원을 내리고 전원 플러그를 뽑고 나
서 360초간 기다린 후 여십시오.
WARNING
Injury may be caused by winding.
Be sure to turn off the power
before cleaning, lubricating,
adjusting or repairing.
10
When repair is needed, properly trained SunStar A/S engineers should be called to
conduct the repair.
1) Cut off the main power before machine cleaning and repair. Wait for four minutes until the
machine is completely discharged.
For cleaning or repairing the main shaft motor and the X/Y drive box,
wait for ten minutes for complete discharge after the power is cut off.
Caution
2) Do not change the machine specifications or parts without substantial consultation with
SunStar because this may cause safety issues during machine operation.
3) Use authentic SunStar parts for repair or part replacement during A/S activity.
4) Put back all safety covers which are removed for repair activities after repair is completed.
Do not operate without finger guard and safety devices. Before threading,
changing bobbin and needle, cleaning, etc., turn off the main switch.
High-voltage current will cause injury. Be sure to wait at least 360
seconds before opening this cover after turning off main switch and
unplugging a power cord.
Make sure to close the cover before operating the machine.
Keep hands away from moving parts of the machine during operation. It
may cause injury.
Advertisement
Table of Contents
