SunStar SWF/B Series User Manual page 128

② Turn the hand wheel and fix it at 100° position. Turn and
fix the cam when the presser foot holder is on the rubber of
the presser foot stopper. Refasten the cam screw #1, turn
the wheel, and tighten the cam screw #2. Make sure that the
roller is not too deep in the cam.
2) Adjusting the Height of the Presser Foot
① Check the relationship between the presser foot and the
needle/embroidery material. Turn the hand wheel to set the
needle at the lowest point (180°). Remove the side plates
and unscrew the presser foot. Use the gauge to adjust the
gap (K) between the bottom part of the foot and upper part
of the needle plate. Tighten the screw. Adjust the height of
each presser foot.
[ Standard K ]
• 1.5mm for the cap needle plate
• 1mm for the flat needle plate (tubular)
Rubber of the presser
foot stopper
Presser foot
controller
Presser foot
controller
bracket
Needle plate
Presser foot
holder
[Fig. 11-9]
Presser foot holder
Screw
Washer
Presser foot
[Fig. 11-10]