7-4-6) Embroidery Design Editing - SunStar SWF/B Series User Manual

7-4-6) Embroidery Design Editing

Press when the operating system loads and you will see a screen like this: The following sub menus are
available for editing the selected design.
1. STITCH EDIT: edits the stitch data of the selected design.
2. DESIGN DIVIDE: divides the selected design into two.
3. DESIGN FILTERING: optimizes the selected design.
■ STITCH EDIT: Editing the stitch data of the selected design
Ex) Editing the design in #5 with the following parameters.
1. Check STITCH 500 and set X and Y at "0"
2.Change STITCH 700 to color changing code.
3. Delete STITCH 800 and input "0" for X, Y and "JUMP" for STITCH 900.
Call the design from #5 and press
For stitch edit, place the cursor at
STITCH EDIT" and press
To move to STITCH 500, move the
cursor UP and DOWN to see the
following screen.
Press to change data.
"1.
1. STITCH EDIT
2. DESIGN DIVIDE
3. DESIGN FILTERING
1] 0
2] 0
DEL INS
1] in the first line is a stitch number, followed by
X data, Y data, and Jump code.
N: normal code
CC: trimming code or needle bar change code
ED: end code.
500] 3
501] 3
DEL INS
The data for STITCH 500 are: 3 (X), –32 (Y) and
Normal Code.
0 J
0 J
EDIT
-33 N
-32 N
EDIT