SunStar SWF/B Series User Manual page 82

(12) ST BACKTACK (Automatic back-tack)
This selects a back-tack, a stitch at the start of the embroidery (to prevent thread unraveling). The default is
"NO."
(13) AUTO BACK (Automatic back stitching after detection of thread break)
This sets the number of the stitches that the frame automatically moves back when it detects a thread break.
The default is 2 stitches and the range is from 0 to 5 in the increments of 1 stitch.
(14) BKRUN ST POINT (Start position of previous needle bar after back stitching)
When the machine stops after belatedly detecting a problem in one or multiple needle bars used (i.e. thread
break), it back-stitches and operates the error needle to correct the empty part, and moves further back to
before the error for all needles to correct undesired embroidery, if any (by stitching over the undesired part).
You can set the number of stitches the frame moves further back for all needles to operate. The default is 3
stitches and the range is 1-20.
(15) FRAME LIMIT (Frame limit)
This sets virtual frame limit function (see 7.4.9.Machine Set-Up). The default is "NO."
(16) JUMP LENGTH (Maximum length of repeated jump stitches)
If the length of total stitches in repeated jump code is longer than the set-up data, the machine jump stitches to
the set-up length, performs trimming, and resumes work. You can set the maximum jump stitch length for this
process. The default is 0mm and the range is 0-50mm in the increments of 1mm.
(17) THE BRK MOVE (Length of automatic frame back-move after detection of thread break)
When the machine stops after detecting a thread break, the frame moves back automatically for convenient
upper threading. You can set the length of this frame move. The default is 0 cm and the range is 0-30 cm in the
increments of 1 cm.
(Only available in SWF/□-W 1201)
■ MACHINE FUNCTION
(1) FLAT, CAP
This sets the type of work materials. The default is "FLAT (0)." To select CAP, input "1."
(2) CORDING
This selects the cording function. The default is "NO (0)" and you can input "1" for "YES."
(3) BORING NEEDLE
This selects the needle and the boring function. The default is "0"and you can select a relevant needle. The
trimming function and thread detecting function of the sclected needle will be off.
1] FLAT, CAP:FLAT
2] CORDING:NO
3] BORING NEEDLE:0
4] SEQUIN:NO