Maintenance And Inspection; 10-1) Check Points For Regular Inspection; 10-2) Cleaning - SunStar SWF/C Series User Manual

MAINTENANCE AND INSPECTION

10-1) CHECK POINTS FOR REGULAR INSPECTION

Safety rules must be observed during the inspection.
CAUTION
① Clean, oil, and grease the set parts of the machine on a regular basis.
② Inspect tension of each driver belt.
③ Failure to perform regular inspections may cause the following:
• Corrosion of P/C circuit board
• Damage to the semi-conductor on P/C circuit board
• Malfunction of the floppy disk drive
• Ill connection of the connector
• Abnormal wear-out of machine parts due to insufficient oiling and greasing

10-2) CLEANING

Sun Star is not responsible for machine damages or malfunctions caused by insufficient
cleaning or oiling.
CAUTION
Turn OFF the main power before inspecting or cleaning of the following parts.
Clean your machine according to the usage condition and surounding environment
CAUTION
NO
1
2
3
Important Parts for Cleaning
Around the hook
Guide rail to the take-up lever
Around the movable blade and the fixed blade
[How to Clean]
Remove the needle plate and pull the
movable blade forward (see picture).
Use the SWF brush to remove dirt and dust.
CHAPTER
Cleaning cycle
Once in 3-7 days
10-1
10
Reference Fig.
Every day
Once a week