SunStar SWF/B Series User Manual page 84

(11) MIN SPEED (Minimum speed limit)
This sets the minimum machine speed. The default is 300 rpm and the range is from 300 rpm to the maximum
speed limit in the increments of 10 rpm.
(12) JUMP SPEED
This sets the speed limit for jump stitching (frame moves without sewing). The default is 750 rpm and the
range is from the maximum to the minimum speed limit in the increments of 10rpm.
Jump speed higher than 750 rpm may cause needle break or mechanical problems in
the needle bar.
CAUTION
(13) INC SPEED (Inching speed)
This sets the speed of inching (low-speed stitching) at the start of the embroidery. The default varies by the
machine type and the range is 50-200 rpm in the increments of 10 rpm.
Machine Type
series
W
T series
series
U
(14) SLOW SPEED
You can work at a slow speed on a particular part of a design by selecting
slow-speed embroidery within the range from the maximum to minimum speed limit in the increments of 10
rpm.
(15) BOTTOM STOP (Lowest point stop of needle after work completion)
This sets the needle bar to stop at the lower dead stop when the embroidery work is finished. The default is
"NO" and you can input "1" to set it to "YES."
[CAUTION]
Do NOT attempt to manually change the needle bar when it bottom stopped.
(16) POWER ORG (Back to start position when power comes on)
This selects the frame to move back to the start position when the power comes on.
(17) FRAME SPEED (Speed of frame movement)
This sets the speed of the frame movement such as automatic return to start position or offset movement. The
default is "LOW (0)" and you can select "HIGH (1) for high speed"
(18) SPEED DATA (Speed set-up data)
This decreases the overall embroidery speed if the work material becomes too heavy for normal operation. The
default is "HIGH (1)" and you can select "LOW (0)" to slow down the speed by 30-50 rpm.
Contents
SWF/ – W1201
SWF/ – WE1204
SWF/ – WE1206·WF912
SWF/ – T1201·T1501
SWF/ – UK1202·UK1502
SWF/ – UK1204·UK1504
SWF/ – UK1206·UK1506
SWF/ – UH1206·UH1506·UH1508
SWF/ – UI1212
Default Inching Speed
100
100
100
180
100
100
100
100
100
. This sets the speed of the