SunStar SWF/B Series User Manual page 99

Press
process.
(2) FRAME ORIGIN
This moves the frame back to the start position. Start position of the frame must be set so the frame can back to the
previous position in case of a power failure.
(3) FRAME LIMIT SET
As there is no physical frame limit switch, you have to set the limit in the software. Input two points on the frame
to set the limit (see picture below.) It produces an error message when the embroidery material goes over the frame
limit set.
To have the error message function, select "DATA SET-UP"
and set "YES." This function is not available on SWF/□ –W1201 and SWF/□ –WE1204.
Ex) Setting P1X=100, P1Y=500, P2X=1500, P2Y=-500
Move the cursor to "3.FRAME LIMIT
SET" and press
to end the
CUTTING NEEDLE SET
1 => USE, 0 => NO
NO. 1 5
[100001000000]
"EMB FUNCTION"
FRAME LIMIT SET
PRESS SET KEY
P1X : 100, P1Y :
9
"15] FRAME LIMIT"
300