Machine Installation; Machine Operation - SunStar SPS/HT-5050B1 Series User Manual

2) Machine installation

Caution

3) Machine operation

Warning
8
Because physical damages such as the functional obstacles and breakdowns are likely to occur
according to the environment in which the machine is being installed. Therefore, the following
preconditions should be fulfilled.
1) The worktable or desk on which the machine would be installed should be strong enough to
sustain the weight (see the nameplate) of the machine.
2) Because machines are apt to be contaminated and corroded by dust and moisture, you
should install Air Conditioner and clean the machines regularly.
Do not operate the machine with radiation cover open. The air filter on the upper side of
control box should be cleaned once a week.
3) Keep the machines out of the direct rays of the sun. If exposed too much to the direct rays
of the sun, the machine may discolor and deform.
4) Keep right and left sides and the backside of the machines off at least 50cm from the wall to
secure enough space to repair.
[Note] The details about the installment of the machine are described in
the machine .
5) Danger of Explosion: In order to avoid danger of explosion, do not run the machine if there
is highly combustible material in the air.
6) Illumination: Because of the peculiarity of the machine, any illuminators are not equipped.
So, users should install the lighting apparatus around the working area.
7) Danger of fall: Do not install the machine on an unstable stand or table. If the machine falls,
it will lead to physical injuries and mechanical damages. When moving the machine,
protect it from outside shock and do not stop abruptly lest it should fall.
SPS/HT-5050B1-01 is manufactured to sew textiles and other similar material.
Be aware that the body of the machine has labels of
part to highlight the safety regulations. In case of running the machine, users should observe
the following things.
1) Before operating the machine, please read the manual and understand fully the details on its
operation.
2) Don't forget to put on the garment suited for the safe work.
Long hair, necklaces, bracelets, wide sleeves etc. are likely to be dragged into the machine
in operation. Wear shoes without slip to avoid danger.
3) When operating the machine, make sure that there is no one near the working parts of it.
4) Keep your hands or parts of the body away from running parts of the machine like a needle,
hook, thread take-up spring, pulley etc.
5) Do not remove any safety cover protecting pulley or shaft, while running the machine.
6) Before opening the electric box such as a control box, make sure without fail to shut off the
power supply and make sure that the power switch should be "off."
7) Before rotating the upper shaft manually, make sure without fail that the power switch
should be "off."
8) When threading the needle or checking the machine after sewing, be sure to stop the
machine.
No. 4 Installating
caution warning
or on each dangerous