Spare Parts; Preventative Maintenance Schedule; Table 5-2 Preventative Maintenance Schedule - Will Burt NIGHT SCAN LITE Instructions Manual

5.4 Spare Parts

To order spare or replacement parts, always refer to the mast model number and serial number.
The model number, serial number, and additional information is engraved on the mast
Identification Plate. Throughout this manual, "P/N" followed by a number represent the part
number for that component. To order spare parts, or for the part numbers for additional
components, contact The Will-Burt Company.

5.5 Preventative Maintenance Schedule

This section describes the systematic care, inspection, and servicing of equipment to keep it in
safe operating condition and to prevent breakdowns. If the system does not perform as
required, see Section 6. If anything looks wrong and cannot be diagnosed and/or fixed, contact
The Will-Burt Company. Table 5-2 provides a schedule of preventative maintenance inspections
and procedures required to keep the Mast System in safe operating condition.
Frequency Inspection
Keep Clean – Inspect to ensure the
As Needed
Mast System is kept clean and free
from foreign material. Dirt, grease,
oil, and debris may cover up a
serious problem.
Damage – Inspect for damage
During
Operation before use. During extension and
retraction of the mast, inspect the
outer surfaces for damage.
Noise – Observe any excessive
During
Operation noise during operation.
Binding – During extension and
During
Operation retraction of the mast, observe mast
operation for evidence of binding.
Damage – Inspect all visible
Weekly
surfaces for damage.
Finish – Inspect the condition of the
Monthly
mast finish. Look for bare metal, rust,
and corrosion.
TP-5554501-B
May 2019
I
NSTRUCTIONS FOR

Table 5-2 Preventative Maintenance Schedule

Original Instructions
N S L
IGHT CAN ITE
Action
Clean as you work and as needed.
Wipe down with a soft cloth or
sponge and a mild solution of soapy
water. If necessary, denatured
alcohol can be used as a solvent.
If damage is apparent, do not use the
Mast System and have it serviced
before use.
If the unit starts displaying noisy
operation, a spray lubricant like PRO
21 (SDS attached) or WD-40 or
equivalent can be applied to joints.
Remove any foreign material or
obstructions as necessary.
If damage is apparent, do not use the
Mast System and have it serviced
before use.
Remove any rust or corrosion with a
wire brush. Touchup any bare metal
with touchup paint. Rust preventative
oil like PRO 21 (SDS attached) or
equivalent can be applied to
components to inhibit corrosion.
& I HD
NFLEXION
5-3