Table of Contents
Advertisement
I
N
NSTRUCTIONS FOR
IGHT
Equipment Damage – Qualified Personnel! All persons installing and maintaining this
equipment should be suitably qualified and work to local, regional, and national standards and
codes of practice.
Safety Instruction – Roof Access! If mast will be mounted to a vehicle, the operator must
provide safe means to access the roof of the vehicle during installation and maintenance.
2.2 Installation Equipment
Table 2-1 lists equipment recommended for installation.
Personal Protective
Safety Glasses
Hearing Protection
Hand Tools
Appropriate Hardware
(Section 2.3)
Manual Ratchet Wrench
Torque Wrench
Wrenches
Equipment
Hoist
Expendables
Clean and Dry Rags
* Note:
Depending on the local, regional, and national standards and codes of practice, and the environment,
additional personal protective equipment may be necessary.
Depending on the Mast System configuration, additional equipment, including but not limited to electrical
components (e.g. wire, switches, fuses, circuit breakers, etc.), may be required.
When disposing of any disposables or components, do so according to any applicable local, regional, and
national standards and codes of practice.
2-2
S
L
& I
CAN
ITE
NFLEXION
Table 2-1 Equipment Recommended for Installation
Recommended Equipment*
Work Gloves
Hard Hat or Helmet
Drill
Measuring Tape
Washers or Spacers
(For shimming)
⅜ Inch Drive 8 Inch Flexible Extension
(Will-Burt recommends Snap-On P/N: BLPEXTF388 or
equivalent drive.)
Sling
®
Loctite
222 or Equivalent
Original Instructions
HD
Nitrile or Vinyl Gloves
Safety Shoes
Level
Multimeter
(To verify power is off)
Wire Cutter/Stripper
Loctite
Equivalent
®
Blue 242/243 or
TP-5554501-B
May
2019
Advertisement
Table of Contents
