Table of Contents
Advertisement
Section 2
This section describes the installation of the system and provides general procedures that must
be followed to ensure a successful installation. Use care to understand and follow all
precautions while installing.
2.1 Pre-Installation Check
Before installing the system, ensure:
All installers read and understand the entire installation procedure
All components are included (Section 1.7)
All equipment is readily available (Section 2.2)
The mounting structure is level with sufficient room to mount the system (Section 2.4)
The base of the mast is installed at a 2.7 meter (8.8 feet) minimum height above ground
level or at a lower height with sufficient guarding or positioning on the vehicle to prevent
contact with the mast during operation.
That the vehicle is stationary and level
That the following precautions are understood and followed:
Trained Personnel Only! Only trained and qualified personnel should perform installation
procedures. Only a properly trained and qualified certified electrician should perform electric
installations. Death or serious injury could result if proper installation procedures are not
observed.
Mounting Structure Hazard! Before installation, ensure the mounting structure is capable of
resisting forces generated from all loading and environmental conditions including, but not limited
to Mast System size and weight, payload size and weight, sail area, wind speed, and ice loading.
The mounting hardware must include proper means to resist vibration loosening such as thread-
locking compound and/or locking hardware. Mounting the Mast System to a structure unable to
resist the forces generated from customer-specific loading scenario could result in death or
serious injury and could damage the Mast System.
Pinch Point Hazard! Keep clear of moving parts. Be sure to stay clear of system during
operation. Moving parts can crush and cut resulting in serious injury. The mast shall be mounted
out of reach of the operator during operation.
TP-5554501-B
May 2019
I
NSTRUCTIONS FOR
Installation
Original Instructions
N
S
L
& I
IGHT
CAN
ITE
NFLEXION
HD
2-1
Advertisement
Table of Contents
