Section 1 Introduction; Intended Use - Will Burt NIGHT SCAN LITE Instructions Manual

Section 1
Review this manual in its entirety. Contact The Will-Burt Company with any questions before
performing any procedure outlined in this manual. The views depicted in this manual are
provided for clarification and are subject to change without notice. Views are not to scale.
This manual describes installation, operation, transportation, maintenance, and troubleshooting
procedures for the Night Scan Lite™ and Inflexion HD™. This manual assumes the use of a
standard catalog Night Scan Lite or Inflexion HD. Procedures and characteristics for systems
customized to meet customer needs may vary.
This manual is for the electro-mechanical Night Scan Lite mobile lighting tower and Inflexion
HD.
This manual is not for the pneumatic Night Scan or Inflexion masts. See
information on these and other Will-Burt products.
A typical Night Scan Lite or Inflexion HD consists of a:

Mast Assembly

Junction Box (P/N: 5549701)

Hand-Held Remote Controller (P/N: 5547101)

Junction Box Cable (P/N: 218103 cut to specified length or P/N: 5563301 for 50 ft. cable)
The Night Scan Lite and Inflexion HD is designed to lift a specific payload for lighting,
surveillance or communication use only. Do not use mast to lift personnel. Contact The Will-Burt
Company with any questions on the intended use.

1.1 Intended Use

The Night Scan Lite and Inflexion HD tower is intended for use by professionals in the
fire/rescue industry to provide emergency scene lighting, surveillance or communication use
only. It is not intended for use by non-professionals. Do not use the mast to lift personnel. The
mast shall be used for its intended purpose within the specification limits defined in this manual.
The mast system is intended to be installed on the roof or in a roof well of fire/rescue vehicles.
The installed elevation of the bottom of the mast base shall be at least 2.7 meters (8.8 feet)
above ground level to prevent reach of upper extremities during operation. Alternatively, lower
elevations are permitted if the mast is properly guarded by the installer or offset towards the
middle of the roof with reach limited by vehicle structure to prevent contact with the mast during
operation.
The mast system is intended to be used only when the vehicle is stationary and the vehicle
parking brake is properly applied. Do not supply input supply voltage or operate the mast
system when the vehicle is in motion. The mast shall remain in the powered-down, nested
position during vehicle motion. The installer shall incorporate the vehicle sensor safety circuit
(see Section 2.6.2.3).
TP-5554501-B
May 2019
I
NSTRUCTIONS FOR
Introduction
Original Instructions
N S L & I
IGHT CAN ITE NFLEXION
www.willburt.com
HD
for
1-1