Table of Contents
Advertisement
I
N
NSTRUCTIONS FOR
IGHT
5.2 Power Isolating Procedure
All power sources shall be removed from the mast system including mast controls, lighting
power, auxiliary device power before performing any maintenance operation on the mast
system.
To isolate power to the mast system:
1. Operate the mast to the desired position for the maintenance procedure.
2. Active the emergency stop.
3. Disconnect all power sources using lock out tag out procedures. It is recommended that
the vehicle ignition keys be held by the maintenance engineer as an additional
precaution to prohibit unexpected power up.
4. Unplug the mast hand held remote control and keep it with the maintenance engineer
during maintenance to avoid unexpected mast operation.
5.3 Maintenance Equipment
Table 5-1 lists recommended equipment for maintenance.
Personal Protective
Safety Glasses
Hearing Protection
Hand Tools
Paint Brushes
Wrenches
Expendables
Denatured Alcohol or Other
Solvent
Rags (Soft, Clean, and Dry)
* Note:
Depending on the local, regional, and national standards and codes of practice, and the environment,
additional personal protective equipment may be necessary.
When disposing of any disposables or components, do so according to any applicable local, regional, and
national standards and codes of practice.
5-2
S
L
& I
CAN
ITE
NFLEXION
Table 5-1 Equipment Recommended for Maintenance
Recommended Equipment*
Work Gloves
Hard Hat or Helmet
Torque Wrench
Glass Cleaner
Touchup Paint
Original Instructions
HD
Nitrile or Vinyl Gloves
Safety Shoes
Wire Brush
Non-Abrasive Cleaners
(Soap and Water)
TP-5554501-B
May
2019
Advertisement
Table of Contents
