Table of Contents
Advertisement
position, adjust the sensor 1 mm closer to the moving base section and tighten the nut to 67-80
N·m. Ensure the lock washer is seated on both sides. The end of the sensor should be
approximately 5 mm away from the moving base section after adjustment. A second sensor
hole is provided on the opposite side of the mast. The sensor can be moved to the other side if
it is more convenient for installation. Follow the adjustment procedure when moving the sensor
to the other side if necessary.
Proximity
Base
Sensor
Proximity Sensor Specifications:
10-30VDC Input Power
100 mA max
Normally Open (closes when mast is nested)
NPN
7mm sensing range
IP 65/66/67/68/69K
The following diagram (Figure 2-16) shows a possible Vehicle Interlock circuit. Other
arrangements can also be constructed. The customer is responsible for choosing the proper
components and providing power to the circuit. The proximity sensor switch is closed when the
mast is nested.
The customer-supplied proximity sensor cable and mating connector are as follows:
Standard female M12x1 Sealed 4-Socket Connector
Wire 22 AWG (0.5 mm
TP-5554501-B
May 2019
I
NSTRUCTIONS FOR
Approximately
5 mm Spacing
Figure 2-15 Proximity Sensor
2
)
Original Instructions
N
S
L
IGHT
CAN
ITE
Proximity
Sensor
Indicator
& I
HD
NFLEXION
LED
M12x1 4-Pin
2-21
Advertisement
Table of Contents
