Installation Hardware; Installation Dimensions; Table 2-2 Installation Hardware - Will Burt NIGHT SCAN LITE Instructions Manual

2.3 Installation Hardware

Table 2-2 describes hardware that may be used during installation. Depending on the specific
installation application, all hardware may not be used.
Hardware*
Base of Night Scan Lite (To the Mounting Structure)
(8) Sets of M14
(minimum) to M16 (⅝
inch) (maximum)
Stainless Steel Hardware.
Junction Box (To the Mounting Structure)
(4) Sets of up to M6 (¼
inch) Stainless Steel
Hardware
HHRC (To the Mounting Structure)
(1) Hook
* Unless otherwise indicated, the mounting hardware shall include proper means to resist vibration loosening such
as thread-locking compound and locking hardware. Torque all hardware as appropriate for its size and grade.
Torque values in these instructions assume the use of Will-Burt provided hardware. Depending on the specific
installation application, all hardware may not be used. Additional hardware may be required for additional
accessories, or customer-specific applications.

2.4 Installation Dimensions

This section describes installation dimensions as follows:

Mast System with RCP and Four X200 Lights (Figure 2-1)

Mast System with RCP and Two X200 Lights (Figure 2-2)

Mast System with RCP and no Lights (Figure 2-3)

Mast System with no RCP and no Lights (Inflexion HD) (Figure 2-4)
Dimensions provided are for reference only and are not intended for vehicle design purposes.
Depending on the Mast System and components being used, the exact design of components
may vary. Adding optional components such as a strobe light or camera may increase the
dimensions of the Mast System.
TP-5554501-B
May 2019
I
NSTRUCTIONS FOR

Table 2-2 Installation Hardware

Supplied By Notes
Customer The bolts should be sized to length to allow for
the thickness of the Mast Assembly Base,
mounting structure, any shims, and all
mounting hardware (e.g. flat washers, lock
washers, and nuts).
Customer The bolts should be sized to length to allow for
the thickness of the Junction Box, mounting
structure, any shims, and all mounting
hardware (e.g. flat washers, lock washers, and
nuts).
Customer The HHRC has a Ø10 mm (Ø0.394 inch)
eyelet to allow the HHRC to be hung in place
when not in use.
Original Instructions
N S L & I
IGHT CAN ITE NFLEXION
HD
2-3