Figure 2-5 Permissible Sling Points - Will Burt NIGHT SCAN LITE Instructions Manual

Unpack the system as follows:
1. Carefully open the shipping crate.
2. Inspect for any shipping damage. Notify the carrier if damage is evident.
3. Remove all loose components.
4. Outfit the mast with a sling and hoist capable of supporting the mast weight. The sling
must support the mast from as least three points. The three sling points are labeled with
the symbol . Attach the sling so that horizontal balance and control can be maintained
while positioning the mast. Do not lift the mast by the lights, RCP or top section.
Permissible sling points are shown in Figure 2-5.
Primary Sling Points
(Both Sides)
5. Slowly lift the mast free of the shipping crate. If necessary, lower the mast and adjust the
sling as needed to balance the mast. The slings should not contact the top tube, RCP or
lights.
6. Ensuring the sling does not catch on anything, lift the mast without any sharp or jerking
motions until it is free of the shipping crate.
7. Slowly move the mast to the desired mounting location. The hoist operator should be
able to view the mast at all times to ensure the mast does not collide with any
obstructions.
8. Slowly lower the mast until the mast is on the mounting structure and the weight of the
mast has settled. Stop lowering the mast once the mast weight has settled.
9. Ensure the mast is temporarily secured to prevent it from tipping over during the
installation process.
The Will-Burt Company recommends keeping the shipping crate for transporting the mast, for
example if shipping the mast back to the factory for refurbishment.
TP-5554501-B
May 2019
I
NSTRUCTIONS FOR

Figure 2-5 Permissible Sling Points

Original Instructions
N S L & I
IGHT CAN ITE NFLEXION
Primary
Sling Point
HD
2-11